Reverse Engineering in SE Wisconsin.
Bring in a worn, broken, or obsolete part with no surviving documentation. We measure it, model it in SolidWorks, and produce a drawing you can use to fabricate a replacement or run copies.
No Drawing Required.
Reverse engineering starts with the physical part. We measure it, account for wear, and produce a CAD model that reflects the original design intent rather than just copying the worn surface.
- Obsolete Components
Parts no longer available from the original manufacturer with no surviving prints.
- Worn Tooling and Fixtures
Worn jigs and tooling that need to be reproduced to the original geometry.
- Parts Without Documentation
Anything made without a drawing, or where the drawing was lost.
- Output
SolidWorks model plus a manufacturing drawing with dimensions and tolerances. Ready to hand to any shop for reproduction.
Bring in the part or send photos and measurements.
Quote within 24 hours. If the part exists, we can model it.